General ESB Boba Fett Holster Paint?

Sarlacc

New Hunter
Hi all,

I'm getting ready to paint the holster I got from Kcr7pr. Is there a specific paint I should get? Does anyone have any suggestions or tricks to make it look good? Thanks!

Paul
 
Ive never painted his holster the orginal is rubber...so you want something like satin black to get that look Id say...Id say plastidip but I dont know if itll hold up getting rubbed on by other stuff....its rubber spraypaint.
 
Laquer thinner will remove paint from stuff pretty easy...I would say...use some rusto auto primer, light grey then their 2x cover satin black...see how you like it if you think its to shiny use some flat clear or dullcoat from testors.
 
Laquer thinner will remove paint from stuff pretty easy...I would say...use some rusto auto primer, light grey then their 2x cover satin black...see how you like it if you think its to shiny use some flat clear or dullcoat from testors.

Nice tip F4R , I have to do mine still, gonna give this a try.
 
use some rusto auto primer, light grey then their 2x cover satin black...see how you like it if you think its to shiny use some flat clear or dullcoat from testors.

This is how I did mine and except for the parts where I didn't clean up my repairs very well it turned out great.
 
Just make sure whatever you use is an enamel paint. I used Rusto Flat Black Protective Enamel. The holster gets banged around a lot so you'll want a hearty paint for it.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top