ESB Blaster stock greebs color?

SEEKER

Well-Known Hunter
Just recieved my MOW greebs. So what's the best colors to paint these babies? any ideas.

blastergreebs.jpg
 
ok well the split plugs should be black with just alittle white chipping off the edges. and the block should be black with a dirty dark red all around the rim of the box.
hope that helps.
Dana
 
Seeker,

Apparently the box shaped greeblie was originally a electronic circuit box that had a red anodized finish to it. This is also the route that was taken on the "JB PROJECT" rifle build up.

:cheers
 
Last edited by a moderator:
Chris, do you know what the original piece was?
All the ref pics I've seen sure make it look like a red or red/orangey anodized aluminum.

I'm currently researching it.
I know it's red plastic because of first hand observation (not from the Fett blaster, but another prop).
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top