ESB Blaster scratch build first time

bassplayer82

Jr Hunter
Hey guys I have been working on my costume for a while now on and off and needed to get the blaster finished. Here are some pics of my build.

I Used 40mm PVC conduit and a joiner for part of the barrel and a flash tube. I bought a toy gun from Ebay for $17 and made some small mods to it. Then I screwed the conduit into the gun, plasti bonded the *&^% out of it and bought 2 pieces of pine and screwed them together. Rasped the butt stock by hand. Still not finished but I am getting there.

IMG_4980.JPG


IMG_4981.JPG


IMG_4984.jpg


IMG_5140.JPG


1779050_10152292995291138_763771299_n.jpg


IMG_4929.JPG


IMG_4932.JPG
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top