ESB Blaster - flash tube

Hi everyone,

I did some searching and haven't found an answer to this question. Does anyone know far the flash tube should be sticking out of the Webley barrel?

I need to get at least an estimate on that measurement for something I'm working on.

Thanks,
GG
 
The actual barrel should be sticking out about 5 1/2" give or take 1/8". The front "barrel ring" will cover nearly 3/4" give or take 1/16".
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top