EE-3 grip questions

Since I'm doing everything else scratch built, I figure I'll do the blaster as well. I have a good plan for the whole thing but the grip. Any suggestions how I can make the knurled pattern on the grip? Even if it was just a thin covering, that would work. I just can't think of how to achieve the pattern.

Thanks,

Eric

...you might try a gun store that carries grips...there are few companies that make rubber grips that could be comparable to the grips you are looking for...

...hope this helps...

Take care
Lewis

That's what I plan on doing, checking a gun or sporting goods store for a set of grips for a large revolver. Doing all the intricate work yourself would probably be quite difficult, unless you're experienced with detailed woodwork.

...the rubber grip would make more sense...it would feel better...

Laters
Lewis

or you could go for a plain wooden grip like mine. I like to think it gives a more battered look

I made a wooden one, it just didn't have the patern in it, other then that it looked ok.

soft woods are a charm to work with actually and I plan on using a little more wood in the future...