EE-3 Carbine modified-

cal196

Well-Known Hunter
This is the blaster I got off eBay it had a loop stock that was fully resin, and about 1 million air bubbles in the mold!! :lol: The pistol grip was to thick to put the shim in so I had to customize a piece of wood for the new grip.
 
Hey Thanks C, yes it was alot of work and many times I told myself, "Why didnt you just leave it alone?" I spend awhile just cutting the resin down so the stock would fit. One day it lasted and snapped off at the weak point of the handle hilt. So I had to start over.
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top