Does Anyone Have a Good Trash Can Armor Tutorial???

Does anyone know of a good Trash can armor tutorial?

i need to know how long should i heat the plastic... what i should heat it with... do i have to bend it in steps?,what type of trash can is best? ect..
 
AFFO$ Trashcan Armor

I don't know about heating it up, except for holding it in front of a hot furnace for a bit (what I did), but if you use the same trashcan in that thread, you shouldn't have to heat and bend anything, since the trashcan already has a good curve to it. I couldn't find that trashcan when I did mine, but I've recently seen them at stores again (the right oval curved trashcans). Good luck!

-Chris
 
Last edited by a moderator:
I feel really dumb now. I put the link to AFFO$'s thread in my first post, but apparently it didn't show up. But I shall edit it now!
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top