Cuting a flash tube???

BobaFettSlave1

Active Hunter
ok. as some of you know. John has just finished those Awsome rubber webleys. Ofcorse I got one myself. I want to replace the rubber flash with my heiland flash. the problem is that the barrel is not hollow. I need to cut the flash to the same length as the rubber one but I dont know how I can get a CLEAN cut around the tube. I DO NOT want to use a haksaw (have had many problems in the past) nor do I want to use a dremmel. I went to Home Depot and the largest pipe cutter they sell is for at most a 1inch. the tube is like 1 and 1/2 inches. anyone know how to solve this delemma? I really want a clean strate cut.:confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused :confused



thanks

Dana
 
I bought one of these at Home Depot, they have it hidden in the PVC section of the store.

Brasscraft
Large Diameter Tube Cutter
Model T005X
026613102580_3.jpg


It will cut up to 2 1/8" OD tubing.

Alan
 
Just a thought,but with such a nice replica wouldn't you consider using at least a Heiland flash tube? It would really look better IMHO. You would just need to hone out the inside of the Webley barrel with a dremel and a sanding drum. You of course would need the flexshaft attachment to get in there. I'm sure dremeling out the rubber wouldn't be too tough and would go rather easy.

Again,just a thought....just a little food for thought.

Steve
 
SEnd me your blaster and flash tube and I will cut it for you. The back end of the flash tube should be filled with rubber so it will mate well with the gun.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top