Cod & kidney armor connect

Roninson

Hunter
Heyya guys-

So as I'm getting closer to "finishing" up my Fett (is there such a thing?), I noticed that my BM cod and kidney armor doesn't meet while worn, thus not allowing for the studs that connect them.

I would like to submit my build for 501st approval at some point -- does anyone know if this will be called out for not being film-accurate? I know it's pretty obscured during most scenes, but wanted to gauge if I'll need to swap it for pieces that do.

Thanks in advance....
 
It is probably best to check with your local garrison command. Some are more strict than others with certain things.
 
Last edited by a moderator:
The studs in the Cod/Kidney piece are attached on screen used costume, but are always hidden by the Girth Belt, so no worry about them.

On RKD armour, the pieces do not meet in any way, the Kidney piece is too short, but that has not prevented the suit from being approved.

On my Fett, the pieces DO fit, but the studs are not there for the moment. The Cod/Kidney piece is held together by the Girth Belt alone. As you can see with my approved costume, the studs cannot be seen from any agle. See here; http://www.thedentedhelmet.com/f20/se-fett-build-finland-now-finished-approved-45159/

Still, as Fettered said, check in with the local Garrison GML, He/She should be able to say how to proceed.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top