chest lights on FP armor question pls..

Luis

Hunter
I see the depression shapes on my FP chest piece where the chest lights should go.. But im not sure what the exact dimentions are for a set of fettronics v3.

I'm ready to paint my armor, but i dont know if i should wait for the board first.

Any help?
 
The depressions are just there as a guide. Measure your board parts to make the exact cutouts. I used masking tape to outline the cutouts and used a combination of Dremel and files to remove material.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top