Chest Light Display: Which One?

SlabFett

Hunter
I have FP armor and I'm trimming out the chest. I figure that I better get the display before I cut too much off.

I'm aware of the TK409 and Fettronics boards. I'm just wondering if there is a big difference? I'm not looking to bash either one I just want to pros and cons. Is there another one out there? Are they still making them?

Thanks for the help.
 
I just put the fettronics in my FP armor. Looks great. I did need to trim the opening a little bit. I then trimmed the smoke material provided by FP to fit in the slots. Here is a pic.
Sorry for the flash. Fettronics stuff is really bright even behind the smoke lexan and with the flash.
DSC_0298.jpg
 
I just put the fettronics in my FP armor. Looks great. I did need to trim the opening a little bit. I then trimmed the smoke material provided by FP to fit in the slots. Here is a pic.
Sorry for the flash. Fettronics stuff is really bright even behind the smoke lexan and with the flash.


Is that red plastic or the greenish plastic in front of your electronics?
 
Just wanted to chime in.

I use PIC chips that can be programmed (by me) to display any sequence, so you don't have to stick with the standard sequence if you aren't regulated by your garrison, or if you're working on a custom mando armor.

Check out www fettronics com for details on custom sequencing you can create yourself.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top