Budgetfett Webley Scott TLC Kit

Firespray

New Hunter
Thought I'd share my finished Budgetfett Webley Scott TLC kit and thank Seven once again for making it possible for me to finally add the ROTJ EE-3 to my collection. Thanks goes out to asok as well for providing the great greeblies. The scope isn't accurate, but I was able to acquire a ROTJ stunt scope mount. Enjoy!

Side_1.jpg


Side_2.jpg


Close-up.jpg
 
Thanks for the nice comments!

Great job! If you don't mind me asking, where did you get the T grips for the barrel?

It's Strip Styrene. I got this info from another member here that used this method. I used 2 sizes of Evergreen strip styrene and glued them together to make the "T". If you want to go this route, you'll need to purchase 2 packages of Evergreen Item# 393 (.125 x .500 x 24") and 1 package of Evergreen item# 389 (.125 x .250 x 24") This is much cheaper than the rubber T grip.
 
Thanks for the nice comments!



It's Strip Styrene. I got this info from another member here that used this method. I used 2 sizes of Evergreen strip styrene and glued them together to make the "T". If you want to go this route, you'll need to purchase 2 packages of Evergreen Item# 393 (.125 x .500 x 24") and 1 package of Evergreen item# 389 (.125 x .250 x 24") This is much cheaper than the rubber T grip.

Awesome thanks for the info! Is there a website to get the strip styrene or is it something I can pick up at a store? Thanks
 
Awesome thanks for the info! Is there a website to get the strip styrene or is it something I can pick up at a store? Thanks

You may be able to find it at a hobby store. I bought mine off Ebay from a seller called MyAtomic Hobbies. They ship fast and the shipping cost is very reasonable.
 
Very nice work.
I'm gathering the extra part (ESB) so i can finish my TLC kit.
I've managed to get all the moving parts to working including the slide that seven said to grind away to allow the barrel to open.
Hopefully i can source all the parts soon.
When i get mine finished, i hope it looks as good as yours.
 
Very nice work.
I'm gathering the extra part (ESB) so i can finish my TLC kit.
I've managed to get all the moving parts to working including the slide that seven said to grind away to allow the barrel to open.
Hopefully i can source all the parts soon.
When i get mine finished, i hope it looks as good as yours.

Thanks aero! My EE-3 is static. No moving parts on this one. I thought about making the trigger work but opted against it. I would love to see some pics of your ESB EE-3 when it's finished.
 
whoooaa. that came out NICE!! the bracket/trigger assembly and the stock were cleaned up very nicely

Thanks! The bracket was a little thin, but I wanted to reinforce it anyway, so that worked out nicely. A little styrene on the trigger assembly, and some filler on the stock and everything is good. The dremel is my best friend. :)
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top