Boot Darts

Omega Man

Active Hunter
Iam thinking of using this game peg for my boot darts, what do you think!

D peg
fabdarts.jpg



The grooved area will be covered with opoxy glue only the tips of the pegs will be visable.
 
Well of course they're not 100%, but I think they'd certainly work :) How will you attach them? From the inside or just attach them to the outside? If you could work the angle from the inside I think they'd do just fine :)

Phil
 
I used nylon bolts for mine. There in the drawers at Home DePot in the bolts/nails aisle. Use a good hand held pencil sharpener to add the point. I just drilled holes in my boots and epoxied them in.
 
I used the pen tips from Dr. Grip pens. Not exactly perfect either, but they don't look bad for a found item.
 
I'm using pen tips on my scratchbuilt boots, too. the pegs, above, aren't 100% accurate, but do look pretty cool.

Quite long though, careful you don't trip up on them, or gouge your/someone else's leg! :eek:

Depending on what your soles are made of, you could drill into them to sink them back a bit, then epoxy them in. They'd then be pretty firm, and not stick out too far.

Just my 1.26 pence worth (£/$ conversion).

Si
 
Last edited by a moderator:
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top