Bobby Fett UK's Scratch Built Jet Pack

If there is a list somewhere under piles of sintra please add my name to it :lol: Absolutely stunning work mate :cheers
 
Last edited by a moderator:
Well what more can I say.
Your project is just getting better and better.

Fantastic stuff, get me on your list too.
;)

Tony
 
Last edited by a moderator:
Hi Dents.

No new photos I am afraid as the pack is covered in rubber (y).

I have started to make the mold. It has taken some time but I am getting there :lol:

I have two greeblies to confirm, one is on order and one I am sure will need to be specially made :facepalm. I am confident the one I am waiting to come in (the switch on the underside) will work as the switch to operate the beacon light, which will be nice 8). I will confirm this in the next day or two. Still waiting for some prices and lead times for the ali beacon and some other finishing touches and I should be good to run an 'interest list' if I can get enough involved I can keep the cost down. I am going to PM the people I know (or can remember) have shown an interest and will then get an official thread posted up - probably Tuesday next week. Feel free to register a pre-interest with me :lol: I love pre's:confused

Thanks to all for your help with different parts of this project

Bobby. :cheers
 
Last edited by a moderator:
Thanks for the PM Rob, did you solve the dilemma of the solid resin missile? oooh that sounds like a Miss Marple story waiting to be written :lol:
 
Last edited by a moderator:
Oh hey, I have a part that may be of some interest to you :)

Laser cut using WOF templates, I think I have 3 left. PM me your address and its yours!
LaserCutJet%20Pack4.gif
 
Last edited by a moderator:
Nice piece Andy... is that the 15" or 16.5" version vent? :)

As Rob has the thing in silicone, I think he may have that part covered?
 
Last edited by a moderator:
Thanks Andy. I am casting at the moment so in one sense it is late, however I am adding the exhaust after as either a resin piece or an more likely an aluminum one.

But big thanks for the offer buddy.
 
Last edited by a moderator:
Think you might want to use one of my sintra laser cut ones as the master for your resin copies? Or did you make one all ready?

Edit:

Wait, I'm stupid. If you're getting them made in aluminum, you can use those as a master.
 
Last edited by a moderator:
There is an extremely large amount of awesome to be had when this pack is finished. I am so pumped for it!

El1te
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top