Best adhesive for FP Gauntlets

tk337

Active Hunter
Best adhesive for FP Gaunts

Hello all,

I'm about to tackle (finally) assembling and painting my FP ESB gauntlets. What do you guys recommend/use as an adhesive to attach the greeblies/rocket/etc.?

Yvette
 
Not got my set as yet, but I would like to screw fix the rocket ann any other sizeable section - thinking flamethrower unit and such. Small parts, for example dental expander, key pad, those greeblies, I would be thinking hot glue, super glue or two part epoxy glue.
 
Last edited by a moderator:
For the larger stuff like rocket/flamethrower/whipcord, I always epoxy bolts into those greeblies, then attach them to the gauntlets w/nuts from the backside. I like to be able to pretty much disassemble them if I would need to, (ie if I decided to do a repaint. ) I always use plastiweld as my epoxy of choice. Hot glue works well for the smaller greeblies.
D
 
Last edited by a moderator:
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top