Which is the best?

Lord Maul

Hunter
<font color="red"> OK I was just wondering if there was a definite answer as to which is the best: Sintra Fiberglass or aluminum? In terms of strength and durability.
Thanks,
 
As far as strength and durabilty, aluminum hands down. The other 2 materials cant take near the beating. My first armor was alumunim, and I found it a pain to cut out, and shape. Also paint doesnt stick to it very well.
 
<font color="red"> Thanks cal196! I think I may have to go with fiberglass as I am very happy with my fiberglass mystery helmet!
 
For Bottom armor . . . I would use Sintra.

Mostly for safety reasons. (If I was to fall - -not too pretty)

But for the helmet - - -Fiberglass all the way.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top