backplate and harness hook interacion problems

Slowmo

Active Hunter
Ok, I finally modded my jetpack with the screen accurate hooks and am using one of fett dads harness with the correct O rings. Those who remember this harness system it doesn't have a bottom so the weight rests on the O rings. My problem is that the hooks on the jetpack are scratching the heck out of the backplate. In essence I should repaint it after every troop and I"m afraid it will eventually wear all the way through the ABS plastic. I'm thinking of putting some kind of thin rubber layer in about a 2"x3" area where each hook seems to rub to prevent the problem but I was wondering if any of you guys have similar problems and what you did to solve the issue.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top