back plate help!

Kaden

New Hunter
i am useing jodo kasts templates that i got from him, size large and i cant seem to form the back plate to set close to my back and to line up with the kneck plate.
 
Hi, I have included the following drawing to help you out. The red lines mark the curve points. (generally)

jkback.jpg


Here's the break down.

1) Bend the side fins - most likely need a heat gun for that
2) Lay the back over a large pot of boiling water. Let the steam heat the plate and holding the fins push the plate down while moving backwards to get a gentle curve from the fins up to the top of the back. (hoe that makes sense)
3) Dip each "shoulder" in the water as far as you can and then hand mold the shoulder piece to a curve that will match your shoulder.
4) Give the piece a quick lateral fold to get some curve to hug your shoulders.
5) Bend the outside tips of the shopulders a few degrees to match the slope of the shoulders.

** When doing the collar armor, heat it up and bend it gently over your stomach bottom point down. Then heat the shoulder tips and give them a nice bend to meet up with the back plate "shoulders".

Hope this helps.

Edit: Ooops, I skipped the part where I strip naked, dance around the boiling pot while sprinkling chicken blood and singing to the sintra gods. :lol:
 
ok i did it and the back plate is fitting much better but now matter how i bend it the kneck does no line up with the back plates kneck, both peices are large. the kneck peice seems to be too big : /
 
When you printed the neck, did you take off any "stretch to fit page" options? Those'll mess the scale up on you.

Here's a pic of my neck and backplate templates next to each other.

NECK1.jpg
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top