Armour templates in MM

Silverstalker

Active Hunter
Hello this will be my first post since my introduction, first off outstanding work all round! to much information to take in everything you could every need.
My question is about the templates I used the WOF ones to make the helmet and will be using others to make the gaunltes next, now the printer at work prints them smaller than the printer at home?

I have played about with all the settings etc but still unsure what the actual size is meant to be, if anyone knows what the width at the top of the gauntlet is in say MM or CM etc I will have my scale..

Am I making sense.

Many thanks
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top