Armor Blueprints Boba / Jango

wizardofflight

Well-Known Hunter
After reviewing the available patterns I figured that I would give it a try myself. I have about 6-7 hours into these drawings so far, still not totally happy yet, but it is a good start. These drawings were done by creating a mosaic from the various photos. I still need to print these out full size to make sure that they are properly proportioned.

Take a look and let me know what you all think.

Thanks

Alan
{See the updated templates below}
 
Last edited by a moderator:
Thanks. You caught me, they are not quite ready yet. I was still collecting references when I post these, but I hope to have them done soon.

Alan
 
If anyone has any suggestions on how to make these blueprints easier to use or other improvements please let me know.

I was thinking on adding a 1"X1" grid to make it easier to scale. Any thoughts?

Thanks guts it great to see them being used.

Alan
 
well grids are always good to go. but i have a question are u sure the top of the back piece is like that? i always thought it was just a smooth curve... but then again i could be wrong...
 
I did a search a while ago and found the templates I have. Now, for some reason, I can't find the site. But the files I downloaded come with instructions on how to print them to size. They also come in S,M,L, and XL sizes for all parts to fit every body type.

Oh, and ;) I have the knee templates. :eek:
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top