Aluminum Beacon Interest

Those look fantastic! Well, so do all your parts! I'm down for an ESB beacon. PM your paypal address and I'll forward payment.

-Ryan
 
Sorry I don't. And the shop I worked at closed in June. So I won't be able to make any more stabilizer.

Serenity
 
Last edited by a moderator:
I was wondering, what is the inside diameter of the beacons ? I make alot of electronics for Darth Voorhees and I am going to make a few boards with pulsing white leds and would like to make sure the wire will fit.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top