Almost done with armor

looking good, cant wait to see it painted.

U should add the tear drop to ur cod piece, I think it would make it look really good.
 
im pretty sure u can just cut a piece out of syntra and glue it to the cod piece. Im pretty sure thats how its done, then u may wanna put a few coatings of triple thick crystal clear spray on, it make it looks like one solid vacuuformed piece.
 
Well, in "helmet" forum, there are several ways posted. Many like to use an adhesive, while others (like me) like to use screws, bolts, or blocks. The choice is yours, really. It all depends on your skill level and how far you want to go.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top