All Boba Fett Armor Stencils and Templates

Hi im kinda new at this and i was wondering what would be a good material to use for the armor for a beginner
 
Last edited by a moderator:
Im new to this prop making also, so i started out with cardboard just to get the feel of making out of sintra or foam core.
 
Last edited by a moderator:
Thanks for the help. making the helmet with cardboard, but I think it's a little to thick. Will make ajustments.
 
Last edited by a moderator:
I made a set out of PVC pipe. Cut it to the length you need. Then cut down on one end and heat it up in the oven at 400 degrees. DON'T WALK AWAY!!!!!! In about a minute or so, the plastic will be soft enough to flatten out. Use two cookie sheets and a thick pair of gloves. Draw your temp and cut. Use a jig saw to cut and a dremmel to sand. My only thought is it feels a little thick so I used a belt sander to thin it out. I need a new camera so I do not have any good pix yet. I'll post some this weekend If I get the chance.
 
Last edited by a moderator:
where can i get helmet temps ive looked almost every where. i just began on my card board armor last night workin on it right now. will post pics when i get done painting it. btw im only 11 and might need some help from the pros
 
Last edited by a moderator:
thank you so much for all the hard work on these i have already cut out and formed most of the armor. moving on to the gauntlets and knees next!
 
Last edited by a moderator:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top