All Boba Fett Armor Stencils and Templates

What about fem armor? I want to make a suit but one that looks like the following? Any blueprints or people that have molds like this?
female_mandalorian_by_spectrestudios.jpg
 
Last edited by a moderator:
3mm is the most commonly used, but you can also use 6mm for more thickness and durability.

This kind of goes along with my question. I assume 3mm would be good for Chest, cod, back, etc, but I do remember him saying his designs for the gauntlets are layed out for 1mm sintra (foamex)

My question is this, might sound dumb, but I want to make sure. I printed out the test page for the chest, belly, etc and had to adjust the output on the printer I was using but I got it to where the scales were exact in real measurements. Can I assume that now I can print out that particular set of templates with the scaling and be right on?
 
Last edited by a moderator:
Massive bump here. Sorry about that.
I'm new to the forum, and new in prop/armor-making, so I just have a question: Will the templates for the knee armor and the gauntlets work with cardboard? Since I've never made anything like this before, I'd prefer to start easy and without all that heating-and-bending or whatever...
 
Massive bump here. Sorry about that.
I'm new to the forum, and new in prop/armor-making, so I just have a question: Will the templates for the knee armor and the gauntlets work with cardboard? Since I've never made anything like this before, I'd prefer to start easy and without all that heating-and-bending or whatever...

Yes you can use cardboard. There are many users here who tried this with great results.
 
Hi great templates ! I'm in the process of making a full aluminium set of armor thanks to your templates . Any tips would be greatly appriciated , cheers !
 
Thank you for these incredible templates and stencils!! This is my first post here on the forum after coming across this site through the RPF. This is exactly what I was searching for as I'm planning to build a complete ESB Boba Fett. I've just scratched the surface of the materials I'm looking for, but I'm thoroughly looking forward to reading through the many threads here as I gather the materials for my build.

Kind regards,
Craig
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top